How I 3D print gears using POM (Delrin)

POM (Delrin) is the gear plastic in consumer robot vacuums, and notoriously hard to 3D print. Here is how I print it reliably: two sacrificial PETG layers first, then POM.

POM (Delrin) is the gear plastic in consumer robot vacuums, and notoriously hard to 3D print. Here is how I print it reliably: two sacrificial PETG layers first, then POM.

OOMWOO’s mechanical design is not drawn from a blank sheet. It starts by researching ready-made parts that can’t be 3D printed (motors/sensors), capturing their dimensions, tearing down and reverse-engineering consumer vacuums to learn the state-of-the-art – and remaking that into…

Future home for OOMWOO open-source vacuum cleaner robot build instructions. Bring-up notes for the sourced motors, fans and sensors – connectors, pinouts and measured currents – are in hardware bring-up, and the CAD pipeline behind these parts is in how…

I’m building a robot that somewhat resembles R2D2 – a round body with a spinning semi-sphere head – NOT a clone for copyright reasons and deep respect to the filmmakers! The robot’s spinning head needs a large, thin bearing. I…

Here is how I made rubberized rollers for my omniwheel home robot. I’ve tried three or more overmolding techniques and concluded that applying urethane rubber overmolding to omniwheel rollers has produced – in my opinion – hands-down best performing and…

If you are reading this post, chances are you have some trouble scraping plastic – of even removing entire 3D-printed parts – off the build surface. There is a bit of a know-how to this chore – here is how…

Once you have made your airtight filament spool container – as described in this post – let’s take care of two more things: Pop quiz question – what type of desiccant are you going to use? Will it be the…

If you 3D-print PLA only, I don’t think you need a dryer. But if you print just about anything else – PETG, ABS, ASA, Nylon, TPU, polycarbonate and so on – keep reading! Most 3D printing filaments, except PLA, are…

If you print only PLA filament, I don’t think you need any of this “nonsense”. Otherwise, if you print just about everything else including PETG, ABS, ASA, Nylon, TPU, polycarbonate and so on – read on! Most 3d printing filaments,…

I use this mount for my Voron 2.4. This mount fits many common webcams – specifically, those webcams that have a horizontal tube-like hole in the back. Here are build instructions and 3MF/STL files. I have included the Autodesk Fusion…
Questions about a kit, an order, or your build? Drop us a note — we usually reply within a day.